ECIDS - A guidance for good practice



During their Concentrated Inspection Campaign (CIC), starting from September 1st and ending on November 30, the two major Port State Control regimes – Paris MoU and Tokyo MoU – will focus on navigational safety. USCG suggests ways for compliance in case vessels have not complied with the recommended ECDIS IHO standards, now that the CICs have begun. 

According to the ECDIS Guidance for Good Practice, it is important where an ECDIS is being used to meet the chart carriage requirements of SOLAS and also to be maintained so as to be compatible with the latest applicable International Hydrographic Organization (IHO) standards.
U.S. vessel owners/operators were encouraged to follow this guidance until end of August, before the commencement of CICs on navigation. However, these U.S. vessel owners/operators that have not met the recommended ECDIS IHO standards by Aug. 31, 2017 may wish to take the following steps when engaging on international voyages
  1. Obtain and retain written confirmation which includes the intended service date to meet IHO standards from the respective ECDIS manufacturer and/or servicing company.
  2. Obtain and retain up-to-date nautical paper charts.
  3. If paper nautical charts are used, ensure navigation officers are fully competent in their use.
  4. Ensure ample advance notice of the situation is given to the Country’s Port State Control being visited.
In addition, for foreign flag vessels arriving into U.S. ports, vessel owners/operators must ensure they are in compliance with the aforementioned SOLAS Chapter V, Regulation 19.2.10 and Regulation 27.
It is also recommended that they are familiar with the guidance found in MSC.1/Circ.1503/Rev.1 – ECDIS Guidance for Good Practice.
USCG Port State Control Officers may verify compliance with SOLAS Chapter V: Safety of navigation, including functionality and operational requirements to ensure the vessel is navigating safely.
If there are any disparities with ECDIS equipment/software, the vessel’s master is encouraged to present the port state control officer with proper documentation from the respective flag Administration, equipment manufacturer and/or technical servicing company, USCG says.

Comments

Post a Comment

Popular posts from this blog

Load test or capacity test of a GMDSS battery

Image
LOAD TEST OR CAPACITY TEST OF A GMDSS BATTERY (24VDC) Over the years of experience as a radio surveyor, it has been observed that the most common mistake that the ship staff does is the maintenance of the GMDSS battery (reserve source). This emergency source is often misunderstood for compliance. In a nutshell let us have a look into what is this emergency source is all about: As per SOLAS regulations it is mandatory for all vessels built after 1995 to have on board an emergency generator. Older ships might have an emergency generator or a battery bank as emergency source. When we speak of sources of energy it is as below:  Main source of energy - Main Generator. emergency source - This supplies power to emergency lights and other applications on board and it is  not the one supplying power to GMDSS equipment. The reserve source of energy is normally a 24V DC - lead acid battery which primarily caters to the communication equipment needs only. The AH capacity o
Read more

Calculation of Load current in GMDSS battery

Image
How to calculate Drain Current and GMDSS battery life during GMDSS SRC Under normal circumstances, it is but natural for the ship staff to get confused with the drain current of GMDSS equipment during survey. This often leads to complicated situation where  a proper explanation becomes crucial to convince the Class surveyor especially if the battery is more than two years old. As per IMO, the GMDSS battery (reserve source) should be replaced once in 3 years irrespective of the condition of the battery after three years. The battery has to be subjected to a capacity load test (similar to your daily routine and weekly routine) once in a month. This is basically done by connecting 6 x 100W DC bulb in series connected to the GMDSS battery. Let us look into a  situation as follows: 1. the above load is connected and 0900 hrs (lt) - Specific gravity and the voltage is recorded at this time. 2. At an interval of 30 minutes, the specific gravity and the voltage has to b
Read more

Safety Radio Survey (aka) SRT/SRC and or GMDSS Radio Survey

Image
Safety Radio Survey (aka) SRT/SRC and or GMDSS Radio Survey In a series of articles that is about to follow in the topic GMDSS Radio Survey or commonly known as SRT or SRC, we intend  to highlight the importance of the GMDSS radio communication equipment on board the vessel and how to prepare the station for Survey. The author of this blog is a 2nd Class COP certificate holder from Government of India, Ministry of Communications and has sailed for over 20 years as Radio Officer and is also a very well know Radio Surveyor with all leading IACS societies in India, viz, Class NK, DNV GL, Lloyds, ABS, BV, IRS etc. Let us start with the basic requirements that has to be in place prior to the Class surveyor's visit to the vessel to carryout GMDSS Survey DOCUMENTATION:  the  following ITU documents  are mandatory to be present on board during the radio survey:- List of Coast Stations - by ITU - Latest edition List of Ship Stations - By ITU - Latest edition List
Read more